primary converter

英 [ˈpraɪməri kənˈvɜːtə(r)] 美 [ˈpraɪmeri kənˈvɜːrtər]

网络  一次转换器

化学



双语例句

  1. Push the primary catalytic converter to one side.
    将初级催化转化器推到一侧。
  2. Research and Design of a New Electronic Current Transducer Primary Converter
    电子式电流互感器新型一次电流传感器的研究与设计
  3. Fit right holder for primary catalytic converter on the crankcase.
    将初级催化转化器的右侧保持架安装在曲轴箱上。
  4. Press primary catalytic converter slightly aside.
    将初级催化转化器轻轻地按到一边。
  5. Fasten primary catalytic converter to the exhaust manifold.
    将初级催化转化器紧固到排气歧管。
  6. PPF can suppress switch's drop-out peak-voltage and magnetic biasing by adding a clamping capacitor on primary side of the traditional push-pull converter's transformer.
    通过在传统推挽电路的变压器原边增加箝位电容,抑制了开关管电压尖峰和电路的偏磁。
  7. For details, see removing and installing primary catalytic converter.
    有关详细信息,请参见拆卸和安装初级催化转化器。
  8. For details see removing and installing primary catalytic converter-"removing" section.
    详见拆卸和安装初级催化转化器-“拆卸”部分。
  9. Unscrew all fastening nuts between primary catalytic converter and exhaust manifold.
    旋下初级催化转化器与排气歧管之间所有的紧固螺母。
  10. To do this, carefully rotate and pull the primary catalytic converter.
    为此,请小心地旋转并拉出一级催化转化器。
  11. Study and Practice of Improving the Primary Dust Efficiency on Converter in BX STEEL
    提高本钢转炉一次除尘效率的研究与实践
  12. High-voltage frequency-conversion renovation of 3~# ventilator of primary dust-collecting system of converter
    转炉一次除尘3~风机高压变频改造
  13. Install support on left primary catalytic converter.
    安装左侧初级催化转化器上的支架。
  14. Release oxygen sensor cable and remove primary catalytic converter in a downward direction.
    松开氧传感器电缆并向下拆下一级催化转化器。
  15. Based on the references and analysis, The primary design of the Converter which is a thin layer of polyethylene for fast neutron dosimeter is founded.
    本文简单介绍了直读式个人中子剂量计的发展动态,在参考比较的基础上,提出了快中子剂量计转换屏设计方案。
  16. Re-fit right holder for primary catalytic converter.
    重新安装一级催化转化器的右保持架。
  17. Optimization criterion was proposed by Laplace-Itae and some primary parameters were optimized by means of the ODE converter technique.
    通过Laplace-Itae建立了寻优准则,并利用ODE变换法对其仿真模型进行了参数优化。
  18. A model of optimized dephosphorization in the primary blowing period for top-blown oxygen converter
    氧气转炉吹炼前期的最佳化脱磷工艺基础
  19. During the second sampling, through the control logic, programmable counters and switch control, realize digital feedback and substitute primary analogue feedback realized by high accuracy D/ A converter.
    在第二次采样中,通过控制逻辑、可编程计数器和开关控制来实现数字反馈,以取代原有的两次采样A/D转换器中通过高准确度D/A转换器所实现的模拟反馈。
  20. Design of primary converter for active electronic voltage transformers with low power consumption
    有源电子式电压互感器一次侧电路的低功耗设计
  21. We employ a coupled inductor and two blocking capacitors in the primary side, which makes the converter achieve wide input voltage and large load ability.
    在一次侧串入耦合电感和隔直电容,使变换器实现了较宽的输入电压和较大的带负载能力。
  22. Design of Primary Converter for Electronic Voltage Transformers Based on Capacitive Divider
    基于电容分压原理的电子式TV一次侧设计
  23. The analog input includes primary current, secondary current, primary voltage, secondary voltage, etc. Controller uses MAX 187 as the A/ D converter, which ensure the sampling speed and the conversion precision in the same time.
    模拟量输入采集的信号有升压变压器一次电流、一次电压、二次电流、二次电压等,采用12位逐次比较式A/D转换器MAX187,兼顾采样速率和转换精度;
  24. Industrial Use of QCS-01 Catalyst in Primary Shift Converter of Ammonia Unit by Gasification under Pressure of Coal-Water Slurry in Texaco Gasifier
    QCS-01催化剂在德士古水煤浆加压气化制氨装置一段变换炉的工业应用
  25. In terms of the characteristics of high voltage, this thesis designed the protection of the primary converter, and optimized the primary measuring circuit.
    本文结合高电压特点,对一次侧转换器部分进行了保护设计,并对一次测量电路进行优化。
  26. The command data can be picked through a simple comparator circuit added to the power-conversion circuit in the primary converter.
    在高电位端控制信号通过在能量变换电路中增加一个比较器电路被提取出来。
  27. The designed control circuit consists of two components: isolating and sampling circuit used for sampling output voltage and isolating primary and secondary of the converter; type 2 error amplifier, designing compensated circuit for error amplifier to stabilize feedback circuit system.
    设计的控制电路由两部分组成:隔离、取样电路,用来采样输出电压并实现变换器初、次级电气隔离;2型误差放大器,设计补偿电路使反馈电路系统稳定。
  28. This kind of new topology is very simple. The inductor does not need store energy at first. As a result, it will not add the stress of primary current, meanwhile, the cost of the converter has been cut down.
    与原方法相比,新拓扑结构简单,电感无需预先储能,在不增加原边电流应力的同时,还降低了变换器成本。
  29. The frequency converter is the primary EMI source. So study on EMC strategy in mine converter is especially important.
    变频器是该系统中的主要电磁骚扰源,故而对矿用变频器电磁兼容技术之研究工作尤显重要。